Properties and Exciting Facts About 2177-47-1

A reaction mechanism is the microscopic path by which reactants are transformed into products. Each step is an elementary reaction. In my other articles, you can also check out more blogs about 2177-47-1

Synthetic Route of 2177-47-1, The reaction rate of a catalyzed reaction is faster than the reaction rate of the uncatalyzed reaction at the same temperature.2177-47-1, Name is 2-Methyl-1H-indene, molecular formula is C10H10. In a Article,once mentioned of 2177-47-1

Pomegranate marcs (PM) and grape marcs (GM) were pyrolysed in a fixed bed reactor to investigate the effects of pyrolysis temperature (400, 500 and 600 C), heating rate (300 and 700 C/min) and pyrolysis atmosphere (nitrogen (N2) and vacuum (25 kPa)) on product yields and properties. Maximum bio-oil yields were obtained at a pyrolysis temperature of 500 and 600 C for PM and GM, respectively, with a heating rate of 700 C/min under vacuum in a non-catalytic procedure. The results show that the pyrolysis of PM yields more bio-oil (43.7 wt%) than that of the GM (27.4 wt%). Therefore, an analysis of variance (ANOVA) was performed to investigate pyrolysis parameters on the yields of the bio-oil and gas products. To study the catalytic upgrading of the pyrolysis vapors, biomass samples were pyrolysed at 500 C using 10 wt% Aluminum-MCM-41 (Al-MCM-41) as a catalyst. The yields and the quality of the bio-oil and gas were influenced using the Al-MCM-41. Based on the GC?MS results, the composition of pyrolysis oil was significantly affected by the presence of a catalyst. The formation of oxygenated compounds and fatty acids was inhibited by the Al-MCM-41, while the formation of aromatic hydrocarbons was promoted. In addition, the HHV (higher heating value) of the bio-oils and the yield of syngas increased using a catalyst. It was observed that the PM and GM bio-oils could be used as a substitute for fossil fuels to generate heat and chemicals and that syngas yields could be enhanced using a catalyst.

A reaction mechanism is the microscopic path by which reactants are transformed into products. Each step is an elementary reaction. In my other articles, you can also check out more blogs about 2177-47-1

Reference:
Metal catalyst and ligand design,
Ligand Template Strategies for Catalyst Encapsulation – NCBI